Por favor, use este identificador para citar o enlazar este ítem: http://dspace.udla.edu.ec/handle/33000/10209
Tipo de material : bachelorThesis
Título : Diseño hidráulico de una planta de tratamiento de aguas residuales para la parroquia Salinas, Imbabura
Autor : Alegría Escobar, Mauricio Andrés
Tutor : Piedra Burgos, Santiago Daniel
Palabras clave : PLANTAS DE TRATAMIENTO;TRATAMIENTO DEL AGUA;AGUAS RESIDUALES;IMBABURA-ECUADOR
Fecha de publicación : 2018
Editorial : Quito: Universidad de las Américas, 2018
Citación : Alegría Escobar, M. A. (2018). Diseño hidráulico de una planta de tratamiento de aguas residuales para la parroquia Salinas, Imbabura (Tesis de pregrado). Universidad de las Américas, Quito.
Resumen : Se realizó el diseño hidráulico de una planta de tratamiento de aguas residuales, que de acuerdo a las características propias del agua analizada en el laboratorio de EMAPA I, se determinó pertinente el dimensionamiento de un tratamiento preliminar compuesto por un canal de aproximación y un sistema de rejillas gruesas finas, seguido de un cárcamo de bombeo, capaz de bombear hasta 25 L s hacia los dos tanques ecualizadores, de donde se circulará el agua residual a un clarificador primario de sección circular, que teóricamente puede retener un 60 por ciento de SST y un 37 por ciento de DBO…
Descripción : The hydraulic design of a wastewater treatment plant was carried out according to the characteristics of the water analyzed in the EMAPA-I laboratory, the sizing of a preliminary treatment consists of an approach channel and a screening system of coarse fine grids, followed by a pumping station, capable of pumping up to 25 L s towards the two equalizing tanks, from which the wastewater will be circulated to a primary clarifier of circular section, which theoretically can retain 60 percent of TSS and 37 percent BOD. Subsequently a trickling filter, whose filtering material 2H PLASDEK type KPP312 612 has a specific surface area of 232 m2 m3, will receive waste water, with the objective of degrading organic matter by means of microorganisms capable of synthesizing it. Finally, the effluent from the TF will be directed towards two circular secondary clarifiers, designed to retain the suspended material and it is estimated that the output BOD would be approximately 25 ppm.
URI : http://dspace.udla.edu.ec/handle/33000/10209
Aparece en las colecciones: Ingeniería Ambiental en Prevención y Remediación

Ficheros en este ítem:
Fichero Descripción Tamaño Formato  
UDLA-EC-TIAM-2018-45.pdf3,71 MBAdobe PDFVisualizar/Abrir


Los ítems de DSpace están protegidos por copyright, con todos los derechos reservados, a menos que se indique lo contrario.